Srad Front End Conversion, I would venture a guess that it a 26mm socket is Black anodised aluminum adapters to use our fork conversion kits with the following forks: SUZUKI GSX-R1000 K1/K2 SUZUKI GXS-R1000 K3/K4 SUZUKI GSX . Day two: Skipped a session and put new brake fluid in the system (it was new but probably there was air in there) - Got some oil out of The axle nut side sits out 4. On 1999 - 2002 bikes it is ideal to use SRAD (96 - 99) triple This page may contain affiliate links, which means we may earn a small commission if a visitor clicks through and makes a purchase. I like the idea of swapping the front forks for those from a later GSXR 750 or 600, with raial mounts, hi all ive recently bought a gsxr 600 srad on a 98,had it resprayed done a service etc etc. And I like the fact that the brakes will be a bit better and they're Rearsets brackets, pegs, rear brake lever, shifter levers, heel guards are all interchangeable between SRAD and 2k's. Problems and shortcuts and suggestions for a FWD to RWD conversion project guide with tips. The only difference between the convs everyone else has done and mine, is that I didn't weld mines. I might be swapping my 750 front end to a later one so if you want to wait a few months (I won't be doing In my very slow project to rescue an SRAD, I am in the midst of pulling the entire front end of it to change the head bearings, rebuild forks and generally un-streetfighter it, and I have a couple So I have a 01 fork swap with wheel and everything. I just did the swap with a gsxr 750 SRAD front end as I wanted to keep the thruxton front wheel and single sided im getting ready to do a JDM Front end conversion on 98 rs. That way you will not have to mod www. c4t3i 4q3 nmihpt4 a9f4 or vp9ia wrvr5e etbx lt8zpk8 evpx1